预制隔离带模具使用方法

使用微信扫描二维码分享朋友圈，成交更快更简单！

预制隔离带模具

预制隔离带模具设计说明在制作的时候要面板的平整性和规格尺寸，这样做出来的模具使用寿命更长，在拼装焊接的过程当中，每个零部件都要按照顺序进行组装，尽量较少螺栓数量，减少我们安装和拆卸的时间，让工人的操作更加简单化。预制隔离带模具在操作的过程中，往往会把吊装环安装在侧面，这样安装的时候就会和钢模板的重心一直，脱模的时间就会缩短，同时提高了工作效率，我们在使用以后也要对模具里面进行清理，看里面是否有杂物，避免影响下次使用，我们通常都是用纱布蘸洗洁剂进行冲洗，洗洁剂用热水稀释后才能使用，清洗过后的钢模具要冲洗干净并晾干。

预制隔离带模具在安装前需要涂上脱模剂，这样在作业的过程当中有较好的压贴效果，在安装的时候也要注意不要有杂物在其中，以免发生变形。

预制隔离带模具   隔离墩模具  隔离带模具

The design instructions of the prefabricated isolation belt mould are to ensure the flatness and specification of the panel when making, so that the service life of the mould is longer. In the process of assembly and welding, each part should be assembled in order, with less bolts as far as possible, reducing the time of our installation and disassembly, and making the operation of the workers simpler. During the operation of the prefabricated isolation strip steel mold, the lifting ring is often installed on the side, so that the center of gravity of the steel template will be kept during the installation, the time for demoulding will be shortened, and the working efficiency will be improved. After use, we also need to clean the inside of the mold to see if there are any sundries in it, so as to avoid affecting the next use. We usually use gauze to dip and wash it The cleaning agent shall be washed. The cleaning agent can only be used after being diluted with hot water. The cleaned steel mould shall be washed clean and dried.

The mold of prefabricated isolation belt needs to be coated with release agent before installation, so as to ensure a better pressing effect in the process of operation. During installation, it is also necessary to pay attention not to have sundries in it, so as to avoid deformation.